ChaptersMelody memory

Calculator and memory

Melody memory

Store a tune of up to 100 notes, then play it back on its own or one key at a time.

ProVerified for version 1.1.0 · Updated October 17, 2026

The old memory trick: tap a tune into the instrument once, then let it play itself, or tap any one key and walk through it note by note.

Store a tune

  1. Slide REC to REC. The LCD shows REC and a note count.

  2. Play the tune. Each note is stored as you play it, in the octave you played it in, up to 100 notes.

  3. Made a mistake? DEL removes the last note.

  4. Slide REC back to PLAY. The LCD shows MEM and the number of notes stored.

AUTO
Plays the stored tune on a loop, one note per beat at the current tempo. Press it again to stop.
1KEY
Either blue key plays the next stored note, and holds it while you hold the key. After the last note it starts over.
MUSIC
Plays the built-in demo tune, an original melody written for PocketTone, on a loop. Press it again to stop.

While AUTO or MUSIC plays, the LCD says so and the keyboard is quiet. The rhythm can run underneath; the playback follows the same tempo.

The memory keeps notes, not timing, so a tune plays back evenly, one note per beat. Storing more notes adds them to the end of what is already there: to start a fresh tune, press DEL until the count is gone. The memory is kept when you quit, and RESET does not clear it.

The melody memory is part of PocketTone Pro. Without Pro, REC, MUSIC, AUTO and the 1KEY keys carry a small lock and open the unlock sheet.

Still stuck? Write to zhi@nonoaudio.com. Support page